Embroidery Placement & hooping for caps and hats

Osman Bayrak

EMBROIDERY PLACEMENT- CAPS

Needle: #75/11 NP
Backing: Cap backing, optional

  • Caps without a built-in backing will require a stabilizing backing like Cap Tearaway backing. This gives the cap added strength and rigidity during the embroidery process. 
  • Solvy topping is recommended if a detailed design is being sewn or if it is a particularly heavy twill.
  • Design size is limited on caps due to the cap construction. The embroidery should not exceed 2"-2.5" tall (depending on the cap construction) and 13" wide.

PLACEMENT CHART

POSITION PLACEMENT

Cap Front

Centered over bill or with front seam, and as close to the bill as the design allows. (Bottom of design should be approximately 0.25" from metal band on cap frame

Left/Right Side

Centered between seams of side panel, approximately 1.5" up from bottom

Back of Cap

Centered on back seam, ½"-1" above opening for adjusting strap

 

SIZE CHART

STYLE

ADULT

CHILDREN

Script on Front

10mm-35mm

7mm-25mm

Block on Front

10mm-35mm

7mm-25mm

Initial/ Number on side

10mm-15mm

10mm-15mm

Name on Back

10mm-15mm

10mm-15mm

HOW TO FRAME A CAP WITH CAP FRAME AND FRAMING DEVICE

STEP 1

Attach cap frame onto cap framing device.

STEP 2

Place a piece of cap backing, large enough to cover the embroidered area, onto the framing device.

STEP 3

Unfasten the adjusting strap on back of cap (unless it is a fitted cap) and fold out hat band.

STEP 4

Place the cap on the cap frame. Butt the underside of the cap bill against the guide plate of the framing device.

STEP 5

Push the cap band up underneath stap band hinge on the left side and the strap band latch on the right side.

STEP 6

Pull the strap band up over the cap, making sure the teeth sink into the seam between the cap bill and the front panel of the cap. Hook the stap band into the latch. Check to be sure the cap is straight before fastening the latch.

STEP 7

Pull the cap taut from the back of the cap, making sure there are no wrinkles.

STEP 8

While holding the cap taut, slide the gathering clip onto the back of the cap.

STEP 9

Take the frame out of the framing device. Handle cap by the cap frame, so as not to loosen the fabric tension of the framed cap. You're ready to attach frame to the machine.

 

If detail is lost, or for minor registration problems, try using a piece of solvy on top of the cap
For front placement only designs, particularly if they are larger, you may leave off the gathering clip to gain a slightly larger field size
For the backs of caps, frame in a conventional 9cm or 12cm hoop and embroider flat.
If holes appear in the garment around the edges of the design check for:
 - Too high of a density for the size sewn?
 - Was the smallest frame size used?
 - Was the correct backing and adhesive used?
 - Use a smaller size needle. Ex. was 75/11 BP used try a 70/10 BP instead

Leave a comment

Please note, comments must be approved before they are published