Rear Edge Sensor Adjustment for your DTF Printer

Media Settings

Check and change the media setting currently loaded in the printer.

Note:

• To change the setting, change the values or setting and then click [Update].
• Multiple settings can be changed at once.
• If the previous version of F/W is installed, the settings may not be properly reflected. Make sure to install the latest F/W.

Rear/Edge Sensor Calibration

Calibrate the rear and edge sensors.

1. Load a media to be calibrated in the printer. Once loaded. click [Next]. The printer will now begin the calibration.
2. Calibration is being performed. Please wait until it is completed. If failed, the calibration will end and the display will go to 5.
3. To start the measurement, remove the media. Once removed, click [Next]. The printer will begin the measurement.
4. Measurement is being performed. Please wait until it is completed. If failed, the measurement will end and the display will go to 5.
5. The measurement process is completed. Click [Next] to go back to the Media Setting menu.