Replace the Pump and Capping Station on Anajet Sprint

Buy the Anajet Pump and Capping Station

Watch a video on Removing the Anajet Sprint Pump and Capping Station

Watch a Video on Installing the Anajet Sprint Pump and Capping Station

Removing the Control Panel

The LCD is very static sensitive, use antistatic protective equipment.

Remove the two Phillips (+) screws that hold the Control Panel to the printer body.
These are accessed from a rectangular hole located beneath the printer. 

• Remove the ribbon cable from the LCD.
• Remove the 2 pin connector from the LCD backlight cable.
•  Remove the flat flex cable from the Control panel cable.
• Disconnect the 2-2pin ground cables from the Control Panel
•  Unscrew the green and white leads from the Print Button Assembly
• Unscrew the two green ground leads from the front body panel screw.
• Reassemble the new Control Panel by reversing the above steps.
• Adjust the backlight and character contrast if required

Ink Delivery System Removal

• Remove the Ink Cartridges.
• Remove Front Body Panel by removing the single front retaining screws and two rear screws securing the front body panel. 

• Remove the Bezel

• Remove the fixed end of the Tube Carrier from the Tube Carrier Bracket.

• Remove the Dampers from the Carriage and Place the Dampers in a plastic sandwich bag above the level of the Print Head to minimize leakage from the Dampers.
• Unplug the cables to J 1 and J 2 from the Ink LED PCBA and the connector labeled PIN1

• Remove the four 6-32 screws from the lower support of the Ink Delivery System. 

• Remove the 6-32 screw from the upper bracket of the Ink Delivery System. 

• Slide the Ink Delivery System forward and out of the Main Chassis.
• Reassemble the Ink Delivery System by reversing the removal steps.

Maintenance Station

• Remove the Waste Ink Tank.
• Release the print head Carriage and move it to the left, away from the Maintenance Stationl.

• Remove screws labeled A1 and A2 in the photo below and loosen the screw labeled A3

• The last remaining screws holding the maintenance station in are shown in the images below.

• The last step is to simply remove the maintenance station. Rotate the maintenance station front end down and then slide it out from underneath.

• Install the new Maintenance Station by reversing the above steps.

Buy The pump and capping station here (Maintenance Station)