DTG Kiosk Fitting the Gap Sensor
Dean Armando
Click here to download the procedure for fitting the Gap Sensor
DTG Kiosk Preparing for an Extended Shutdown
customer
Transporting or Storing Your Printer It is extremely important you observe the following before transporting or an extended shutdown of your DTG Kiosk. Preparing the Printer for Transportation If the printer is to be transported over a long distance, and/or by a common carrier (where you cannot control the "care"...
DTG Kiosk Installing the WIMS Ancillary Board
customer
To learn how to install WIMS to Kiosk, click here. KIOSK PARTS HM1 PARTS INK
Diagnosing a Clog in the Kiosk II
customer
What I normally do is to try to isolate the issue from several possibilities to one. The only way to do that is to swap dampers. Follow these instructions to see if it is the damper or the print-head. Perform a nozzle check, and note the bad nozzle check and...
Setting up Your DTG Kiosk Checklist
customer
Download the DTG Quick Set Up Guide Also, try downloading the DTG Kiosk BASICS Manual Start to Finish List of Setting Up Your DTG Kiosk (1) Inspect carton for damages. (2) Open carton. (3) Remove top cardboard and set aside. DO ONT DISCARD ANY PACKING MATERIALS (4) Inspect to make...
VIDEO DTG Kiosk 1 Using the Ink Valves
customer
Take a look at our newer direct to garment (DTG) models on our page down below. https://www.garmentprinterink.com/collections/dtg-printers/products/ricoh-ri2000-commercial-garment-printer https://www.garmentprinterink.com/collections/dtg-printers/products/ricoh-ri1000-commercial-garment-printer
How to Change Your Ink System: DTG Kiosk 1 Video Tutorial
Sean Krueger
Check out this insightful video tutorial on changing the ink system for the DTG Kiosk 1 direct-to-garment printer. This crucial step ensures vibrant prints on various materials.