Anajet errors: hangs at Auto System Maintenance
customer2 comments
Anajet errors: hangs at Auto System Maintenance, displays other errors, then loops back to Auto Syst Maint again.
Jobs that require the PRINT button- such as Nozzle check, purge nozzle, or new print jobs from EKPrint Studio- the system will do a continuous loop of Print head clean and ink charge first and drain my cartridges
Then green READY light and yellow WAIT start blinking and several different error messages keep displaying on the control panel. At this point the machine hangs and there is no activity.
Answer:
Make sure that your printer queue on the computer is cleared. Sometimes it gets confused when there are multiple actions in the queue. OR your main controller board is bad
Comments (2)
I had the same problem with my Anajet FP125 printer as it is stuck in Auto System Maintenance Mode
Firstly use a clean cloth with 50\50 isopropyl alcohol and instilled water to clean the encoder strip
Second check the LED board to see if there any Red Lights coming up
Third if there is Red light coming up on the LED board reseated and clean the INK Chip Holder with dry clean applicator and if the RED light is still coming up order for another ICH INK Chip Holder and see if it’s work before you take the steps
As for me I’m still waiting for my new INK Chip Holder in the mail
Hey guys,
Picked up another Anajet FP 125 as a backup to the two I have. When it powers up I originally was getting the reset service counter beeps. I got by that and now it’s stuck in “Auto Maintenance Mode”. Any suggestions?
Brian