Anajet mPower Support

This guide will show you how to clean a needle valve assembly.   Symptoms Poor Nozzle Check Dampers have trouble filling White Ink Separation   WARNING: MAKE SURE TO TAKE NOTE OF HOW THE NEEDLE ASSEMBLY IS PUT TOGETHER BEFORE YOU TAKE IT APART AS YOU CAN PUT IT BACK...

Symptoms No movement at table. Table Motion Control board not displaying green lights.   Step by Step Guide Power down printer from the back. Lift hood and unplug the 5 cables from the table board shown in the image below. Cable 1: Lift white tab up in order to disconnect...

The Print Engine Does Not Turn On During the print engine power up sequence, the Control Panel Power LED will blink and LCD will display a splash screen. When the print engine properly completes the powered up sequence and the blinking Power LED becomes steady on, the Print Table will...

Your browser does not support the video tag. If the Nozzle Check is not good, you will need to perform a Print Head Clean. A Print Head Clean is performed from the Printer Control Panel under the Main menu. Press the<MENU> button and select Print Head Clean and press <ENTER>....

The Encoder Strip located on the back of the carriage should be cleaned on as needed if becomes covered in ink mist or if ink has landed on the strip. In order to clean the encoder strip, you will need to first release the print carriage. From the Maintenance menu...

Check the Ink Drip Foam located on the left and right sides of the printer regularly. Replace them as needed when they are soaked with ink or excessive ink residue builds up. If you use a lot of white ink, you will have a more rapid buildup of ink residue....

Your browser does not support the video tag. Now that the lines have been filled with ink you will need to perform a Nozzle Check. First we need to set the table height by pressing the <AnaJet> button. This will lower the table, move it into the printer and raise...

There are many reasons you may need to take out a print head on the Anajet mPower MP5 or MP10.  Whether it's to clean or replace, watch this video to learn how to make this common repair on your Anajet Printer. If you need to CLEAN your Anajet mPower print...

Introduction This is a troubleshooting guide on how to resolve issues with air or gaps in the lines of the ink tubes cause banding, color drop out and bad nozzle checks. Scope This applies to mPower printers only. Symptoms • Color drops out and comes back• Visible gaps in ink...