Anajet mPower Support

When a job is sent from the PC, the job will be loaded into the printer and shown on the LCD screen. If this does not happen, the printer did not receive the job or did not receive a job properly. The problem is likely to lie in the computer...

If an Application Error appears on startup verify the purple USB cable is connected to the Carriage Controller (located on the carriage, print head controllers plug into this) and the USB-ETH-CAN- Switch Board (located next to the waste tank). Check to make sure all the boards have power and all...

During the print engine power up sequence, the Control Panel Power LED will blink and LCD will display a splash screen. When the print engine properly completes the power up sequence and the blinking Power LED becomes steady on with a blue light around Power button, the Print Table will...

mPower Pre-Shipment Instructions If your printer is under warranty, you are responsible for arranging and paying for inbound shipping. AnaJet will arrange and pay for outbound shipping. If your printer is not under warranty, you are responsible for arranging and paying for both inbound and outbound shipping. Pick up specs:...

You can also set up your Network Connection through your Printer Settings menu. To adjust your network settings, select Network tab in the Settings Menu. You will have the option of setting your Ethernet Mode to Dynamic, or Static. You can change this option using the drop down arrow. Static:...

  CAUTION: IF THIS IS A NEW PRINTER, REMOVE THE 2 RETAINER BRACKETS ON THE PRINT TABLE AND PRINT CARRIAGE BEFORE POWERING ON OR IT WILL DAMAGE THE PRINTER. Follow the setup steps in your User Manual, Chapter 2: Startup of a New Printer Plug in the provided power cord...

To access the Technical Support Menu press <Menu> button and then press the <Print> button 8 times. The Advanced Menu will appear.

Operation (with inks loaded): 61°F to 90F (15°C to 32°C) Storage (without ink): 14°F to 104°F (-10°C to 40°F) Temperature (storing inks): 41°F to 90°F (5°C to 32°C).

It is crucial for trouble-free printer operation that the Relative Humidity(RH) requirement is met at all times when the printer is loaded with ink. Operation (with inks loaded): 45% to 80% RH, non-condensing. Storage (without ink): 20% to 85% RH, non- condensing. If the environment is below the specified Relative...

Ricoh printers are designed to be used with a PC running Windows XP, Windows Vista, Windows 7, Windows 8, and Windows 10 Operating System. The programs needed to run your printer do not work on anApple computer system unless it is running Windows emulation software such as Parallels, Bootcamp or...

Your browser does not support the video tag. Removing retaining brackets It is very important that the printer be operated on a stable, sturdy and level table. Ensure that the table is sturdy enough so the printer does not shake or vibrate during operation. Operating the printer on an unstable,...

Fully power down the printer and switch off in back of the printer. Check behind the table when it is out for obstructions first then move the Print Table by hand. Move the table all the way to the front (Load Position) and then push it all the way to...

Verify the Quality mode you are printing in. The three modes available are Draft, Speed, and Fine. The Speed and Fine modes increase the printing resolution and lay down more ink and increase the printing time. Do not run too many programs on your computer at the same time. Close...